M12 to flying leads, dc input, 15m

The CBL-PWRD150-M12M00 is Zebra's 15 m "M12 to flying leads" DC power cable, designed as a DC input line cord for powering equipment (such as FXR90 RFID readers and similar) from a 9-60 VDC source using a threaded M12 connector on one end and stripped leads on the other.

Connectors, length and intended use

• Length of 15 meters (≈49 ft), allowing DC power to be brought to mast, ceiling or outdoor mounted devices from a remotely located source (cabinet, technical room, etc.).

• One end terminates in a 5-pin M12 threaded circular connector that mates to the DC input of the equipment (e.g. FXR90); the other end is stripped wires (flying leads) for connection to a DC source or to the output of a PWR-BGA24V90W1WWW / PWR-BGA24V100W1WWW converter.

• Zebra states that it is intended "for use with 9-60 VDC source" and requires PWR-BGA24V90W1WW/PWR-BGA24V100W1WWW, which ensures the correct combination of voltage and power to the reader.

Wiring, pinout and security

• The FXR90 guide details the colour coding of the cable end:

  • Red (pins 1 and 2): DC_IN_POS (9-60 VDC).

  • Black (pins 3 and 4): DC_IN_NEG (GND).

  • Blue (pin 5): ENABLE (default ON, disabled if set to GND; must not be connected to more than 18 Vdc).

• The connection must be carried out by qualified personnel, in compliance with local electrical regulations and using certified junction boxes, terminals or connectors and, if outside, suitable watertight elements.