Cat6a Ethernet Cable - 10m Lszhcabl 10gbe Network Patch Cable

The StarTech NLBL-10M-CAT6A-PATCH is a 10-metre Cat6a Ethernet patch cable built for 10 Gbps networks. Rated at 500 MHz, it is optimised for 10GBase-T deployments and helps improve signal reliability with low near-end crosstalk (NEXT) and return loss (RL). Both ends terminate in straight RJ-45 male connectors, so it connects switches, patch panels and PoE devices directly.

The cable uses 27 AWG stranded pure copper conductors with S/FTP (S-STP) shielding: an aluminium/mylar foil plus braided shielding for greater protection against electromagnetic interference (EMI). The shielded connectors are gold-plated (50 microns) and include protective connector covers. The low-smoke, halogen-free (LSZH) round jacket is safe for enclosed spaces and emits low levels of toxic gases in case of combustion, while its flexibility makes it easier to route through tight spaces.

It supports Power over Ethernet (PoE++) up to 100 W and complies with the IEEE 802.3bt Type 4 PoE++ specification. Each cable is individually tested to meet ANSI/TIA-568.2-D, is plug-and-play ready, and carries CE and RoHS conformity. It is supplied as 1 piece in a package measuring 310 x 220 x 45 mm.

Características principales

• Cat6a cable, 10 m length, optimised for 10 Gbps / 10GBase-T networks at 500 MHz
• S/FTP (S-STP) shielding: aluminium/mylar foil plus braided shielding against EMI
• 27 AWG stranded pure copper conductors for reliable signal transmission
• LSZH (low-smoke, halogen-free) round jacket, suitable for enclosed spaces
• Shielded, gold-plated (50 microns) RJ-45 male connectors with protective covers
• PoE++ support up to 100 W, compliant with IEEE 802.3bt Type 4
• Individually tested to ANSI/TIA-568.2-D; CE and RoHS conformity

Especificaciones

Preguntas frecuentes

What network speeds does this cable support?

It is a Cat6a cable rated for 10GBase-T with a data transfer rate of 10000 Mbit/s and a frequency of 500 MHz.

Does it support Power over Ethernet?

Yes. It supports PoE++ with a power budget of up to 100 W and complies with the IEEE 802.3bt Type 4 PoE++ specification.

What type of shielding and jacket does it use?

It uses S/FTP (S-STP) shielding with aluminium/mylar foil and braided shielding, and a halogen-free (LSZH) round jacket.

What connectors does it have?

It has two straight RJ-45 male connectors, both shielded, with protective connector covers. The conductors are 27 AWG stranded copper.

Es para ti si...

• You are deploying 10GBase-T networks or switches and need a 10 m Cat6a patch cable.
• You need shielded S/FTP cabling to reduce electromagnetic interference.
• You power devices over PoE++ up to 100 W.
• You route cables through enclosed or tight spaces where an LSZH jacket matters.